![]() ![]() Put prime/spray valve to UP position, then hold trigger in for 10 seconds. If more flushing is needed, remove the tip from the sprayer. ![]() For best results, do not spray more than one cup of water through the tip while cleaning. The motor will operate normally after cooling for 20-30 minutes. If the motor stops, the thermal switch has tripped. Overheating Protection Overheating Protection The motor has a built-in feature to protect itself from overuse. If spraying in low pressure range, there may not be enough pressure to clear the plug. ![]() To exit this mode, turn pressure control knob down to lowest pressure setting that results in an acceptable spray pattern. This mode is noticeable by the sprayer sounding like it is slowing down and will result in a poor spray pattern. Thin materials sprayed at high pressure settings may cause the sprayer to enter an operational mode designed to protect it from overheating.Keep hands and other body parts away from the discharge. Do not aim the sprayer at, or spray any person or animal. Pressure Relief Procedure Always engage the trigger lock when you stop spraying to prevent the sprayer from being triggered accidentally by hand, or if dropped or bumped. ti3509a Never use an outlet that is not grounded or an adapter.Ĭommon Procedures Common Procedures Trigger Lock Follow the Pressure Relief Procedure whenever you see this symbol. ![]() This 120 Vac sprayer requires a 120 Vac, 60 Hz, 15A circuit with a grounding receptacle. Grounding reduces the risk of static and electric shock by providing an escape wire for electrical current due to static build up or in the event of a short circuit. Using Electrical Cords Using Electrical Cords Grounding and Electrical Requirements Sprayer must be grounded.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |